Home > Windows Xp > Rebooting XP Computer With 2 Hard Drives Issue

Rebooting XP Computer With 2 Hard Drives Issue

Contents

No more fiddling with the drive cables if spare drive booting needed! Now I can only use it in safemode, and it won't start in normal, it freezes before we even get to the desktop. After windows open run chkdsk from command prompt. Don't leave it to chance! More about the author

They should have immediately advised you to do this. then all your REGISTRY-entries on D also refer to the C-drive. Jul 26, 2005 #5 stormcat TS Rookie Hi Cardpopper From your description I understand that it is a program which enables you to select any one of two HDs to boot On speaking to them again the tech asked me to change the cable to VGA from the DMI port as that could be the reason for the problem.

Windows Xp Restarting Again And Again (solved)

The boot order is changed from here.

Notice the key guide in the top-right corner. Attach one end of the SATA data cable (which is keyed for correct insertion) to a SATA port on the motherboard or interface card, the other to the drive. Hard Drive 4.

  1. You are better off using a program like Disk Image and imaging your C-drive to e.g.
  2. Just got 1T seagate cuda back in sept 08, since im such a big gamer i filled all but 150 gigs of it, i kept my old 250G seagate and split
  3. However, the above does not say which Windows Installation disk to insert.
  4. Again, only works as listed for my particular configuration.

Boot up your Win7 install disk and do a Repair Install. I quickly did a drive to drive copy while it was working. Cause 3: HDD is damaged A hard drive can become damaged or inaccessible due to read/write errors, power outages, or virus attacks. Unmountable Boot Volume That helped me boot the non-Dell drive, and to make all necessary setting changes in Windows for RAID.

The rest is just guess work at best. Windows Xp Recovery Console No signs, nothing. Dec 9, 2003 #1 Spike TS Evangelist Posts: 2,168 Nice bit of info there! Since then I keep back up of each and every piece of document. ?

And good luck! Reboot And Select Proper Boot Device To check the boot order, follow these steps: Restart your computer Press the necessary key to open BIOS menu. The only fix for this is a registry tweak so that Windows XP can’t see the Windows 7 drive.Have you considered using the virtual Windows XP on Windows 7 it is The HD cables could have come loose or gone bad...

Windows Xp Recovery Console

If you had changed the bios to AHCI or RAID, then the XP install would have failed without using the F6 additional drivers step. Before doing that, I need to know if there is anything else I can try. Windows Xp Restarting Again And Again (solved) Replace the hard drive cable or at least unplug it and then re-plug it back in again. Windows Xp Recovery Disk The SMART technology while useful under certain circumstances had an extremely wide margin of error and would throw errors on boot occasionally when there would be nothing from either a physical

This box is titled "INITIALLING FOLDERS: INITIALLIZING THE ROOT FOLDERS TO DISPLAY" This usually takes a minute to three to complete. *Finally, when closing out of an internet page, I will my review here Submitted by: Marlene O.This answer was voted most helpful by our community membersAnswer: Disk Boot Failure - Some Things To Try Marlene,The disk boot failure could come from a number of Install XP on one drive. Once or twice in the six weeks since I purchased the computer, the error did not appear. Stop: 0x0000007b

Anybody have a clue as to what to do? After 10 (or less?) years, the battery (in my Windows XP desktop computer) wore-out. Reply Catalin says: May 31, 2010 at 1:29 am Also my laptop was working fine….. click site move the CMOS jumper to the second jumper position for 5 seconds3.

I over simplified explaination. Easy Recovery Essentials First, Try a test, put a floppy disk that you know is bootable into the floppy disk drive. You can then install a brand spanking new hard drive and load all your applications and files to it.

Windows XP's System Restore Facility If your Windows system has suddenly started misbehaving, for example after you perform a software installation or update, the Windows System Restore facility lets you restore

The interesting thing is that it didn't touch the Win7 boot loader even if I had not detached the drive during the XP installation.Regards,Erling Ask a new question Read More Hard check the drive selection on the Hard Drive next to the Data Cable, there should be an indication of which pins are for Master, Cable, or Slave selection. Odds are it'll report that everything is OK but it's good to know. Windows Xp Download Click Start > Control Panel > Administrative Tools > Computer Management, and choose Disk Management from the tree at left.

Things were "ok" (still occasional freezing) for awhile. LEAVE IT ALONE! (Overlook the fact that the "S" in "WINDOWS" is on a second line. getting stuck or tutter, and because of that PC g etting hang many time, are any one able to know what is the problem and what is the solution? navigate to this website Backing Up Your Own Files If you computer has system problem, you first priority should be to make sure you have up-to-date backup copies of all your own files.

Boot Easy Recovery Essentials from the CD, DVD or USB Select Launch Command Line To download Easy Recovery Essentials, click here. If your backup=scsi disk D contains a mirror of C. Reply Eric says: June 11, 2010 at 9:17 am My hard drive light keep busying for few minutes sometimes, wonder if that's a sign also. Put that in and then a few weeks later, same thing, this time I made Dell take it in for repair.

pjmelectApr 29, 2011, 5:46 AM One problem with dual booting Windows XP and Windows 7 is that when you boot into Windows XP it will delete Windows 7 restore points.